Pack of 2 Berkey PF-2™ filters for fluoride and arsenic reduction

Berkey PF-2 filter - fluoride and arsenic cartridge

€112,00
Skip to product information
Pack of 2 Berkey PF-2™ filters for fluoride and arsenic reduction
  • Pack of 2 Berkey PF-2™ filters for fluoride and arsenic reduction
  • Tutoriel d'installation et d'utilisation du purificateur Berkey
  • berkey filtration elements Berkey PF-2™ filter - Berkey fluoride and arsenic cartridge
  • berkey filtration elements Berkey PF-2™ filter - Berkey fluoride and arsenic cartridge
  • Vidéo explicative - Comment fonctionne le système de filtration Berkey
Berkey PF-2 filter - fluoride and arsenic cartridge

Berkey PF-2 filter - fluoride and arsenic cartridge

€112,00

FOUNTAINE WATER · REPLACEMENT FILTERS

Berkey PF-2™
The pair of fluoride and arsenic post-filters

Complete your Berkey® filtration with a stage dedicated to reduction of fluorides and arsenic. PF-2™ cartridges attach under your Black Berkey® or Phoenix Gravity New Millennium Edition™ main filters, inside the lower tank.

💧 Additional filtrationBlack Berkey® and Phoenix compatible2 cartridges supplied

✓ 2 Berkey PF-2™ post-filters included. Black Berkey® or Phoenix fountain and main filters sold separately.

2 filters

1 pair of PF-2™ cartridges

15.2 cm

Length of a cartridge

3,785 L

Replacement mark by pair*

12 months

Maximum expiry date after commissioning*

Dimensions, content and compatibility of PF-2™

Features Detail
Reference Berkey PF-2™ — fluoride and arsenic post-filter
Quantity supplied 2 cartridges, i.e. 1 pair
Dimensions of a cartridge Length: approximately 15.2 cm ; diameter: approximately 6.35 cm
Reduction media Activated alumina in the form of fine granules
Cartridge body No. 5 polypropylene without BPA
Targeted substances Fluorides, arsenic V and preoxidized arsenic III
Compatible main filters Black Berkey® BB9-2 and Phoenix Gravity New Millennium Edition™
Location Beneath the main filters, in the lower bowl of the Berkey® system
Number to install 1 PF-2™ per main filter in use
Compatibility exception No compatible with the Go Berkey®
Recommended replacement by the manufacturer Each pair: 1,000 US gallons, or approximately 3,785 L, or 1 year — whichever comes first
Manufacturer's commercial warranty Limited warranty 6 months, under the conditions of New Millennium Concepts, Ltd.

* Replacement at the earliest due date, for each pair in service. Dimensions rounded from manufacturer's values: 6 × 2.5 inches.

A targeted supplement for your drinking water

Water passes first through the main filters in the upper tank, then through the PF-2™ cartridges suspended in the lower tank. Their media retains the targeted substances on its surface: this is the principle of adsorption.

The PF-2™ thus complements the Black Berkey® or the Phoenix for the reduction of fluorides and certain forms of arsenic. They are used with the main filters adapted to your system.

The actual capacity depends in particular on the concentrations present in the water and its pH. The manufacturer indicates optimal efficiency between pH 5 and 7. These conditions must be taken into account to assess the advertised performance.

THE CONTENT OF YOUR ORDER

Choose the right number of cartridges

This offer includes a pair of two PF-2™. It allows you to equip a system using two main filters. A four main filter configuration requires four PF-2™s.

Main filters and fountain are sold separately.

LITERAGE AND USAGE TIME

Two markers for replacement

Note the date of installation and track the volume of water filtered. For each pair of PF-2™, replace cartridges as soon as Approximately 3,785 liters or 12 months are reached.

Earlier replacement may be necessary depending on water quality and usage. The 3,785 liter mark corresponds to a pair.

The 6-month manufacturer's commercial warranty concerns the conditions of support for the product. It is separate from the replacement frequency.

PRIMING AND ASSEMBLY

Installation in just a few steps

  • Prime each PF-2™ with cold water, in both directions, according to the instructions, until the water runs clear.
  • Screw the threaded end onto the stem of the main filter already installed. Do not exceed 8 turns and do not force : excessive tightening can damage the internal sieve.
  • Replace the tanks, carry out a first fill and discard this first filtered water.

Consult the official instructions in French before the installation

DAILY

Understanding the flow rate with PF-2™

The addition of PF-2™ creates an additional filtration step. The system flow rate may therefore decrease, particularly when the water from the lower tank reaches the bottom of the cartridges.

This slowdown is part of the intended operation. Allow the time required for filtration and check priming if the flow becomes abnormally low.

THE RIGHT REFLEX

Dye test: remove the PF-2™ first

Always remove the PF-2™ before performing a red dye test on your system.

The assembly test concerns the main filters and their mounting points. It does not measure the effectiveness of PF-2™ against fluorides or arsenic. Follow the instructions corresponding to the main filters you are using.

Origin: Berkey PF-2™ filters are manufactured and assembled in the United States.

Instructions, advice and documentation
Specialists in gravity filtration for over 15 years

Coming from a pharmaceutical background, I select each system with a requirement for reliability and transparency — for pure water, without complex installation, which preserves essential mineral salts.

  • Pharmaceutical expertise
  • 15 years in gravity filtration
  • Rigorous & transparent selection
  • Ecological & sustainable solutions
Shipping

With colissimo, we will endeavor to ship your order as quickly as possible. Free delivery to a relay point from €89 in France. Prices >>
Manufacturing

Our products are manufactured by internationally renowned companies. We carefully select our manufacturing partners to ensure our products are high quality and fair value.

You might also like!
  • 5 stars: 6 (86%)
  • 4 stars: 1 (14%)
  • 3 stars: 0 (0%)
  • 2 stars: 0 (0%)
  • 1 star: 0 (0%)
d
da costa christophe
filtre

trés bien ,le lavage est un peu laborieux

J
Jean Sejourne
Ras

Rien à dire, j’attends encore quelques semaines pour tester mais pour l’instant nickel peut-être un petit souci quand la deuxième bonbonne est remplie et si l’autre au-dessus est rempli ça peut couler entre les deux et fuir donc pense à ne pas trop les remplir quand même, surtout celui du haut

Bonjour,

Merci d'avoir laissé un commentaire sur notre produit Filtre PF-2™ Berkey. Nous sommes ravis de savoir que vous êtes satisfait jusqu'à présent. Pour éviter tout débordement entre les deux cuves, nous vous recommandons de remplir la cuve supérieure par tiers lorsque la cuve inférieure n'est pas vide. Par exemple, si la cuve inférieure est remplie aux deux tiers, remplissez la cuve supérieure à un tiers. Sinon, attendez que la cuve inférieure soit complètement vide avant de remplir la cuve supérieure entièrement ; cela optimisera l’efficacité des filtres.
Merci pour votre confiance en notre produit.

Cordialement,
Le service client

r
ruddy Beuve
Burkey filter

Tres bien comme filtre !!!

R
Roberto Aveleyra

Filtre PF-2™ Berkey - cartouche fluorure et d'arsenic

O
Olga Thiebaut
Commande Berkey

Très satisfaite des produits Berkey (filtre à eau et recharge gourde . Livraison rapide au bout de 3 jours . Merci

K
Kora Matthaes

bonjour, nous ne l'avons pas encore reçu. le colis est arrêté pour dédouanement faute d'informations de votre part. j'espère le recevoir la semaine prochaine.

A
Alexandra COIN
Parfait !

Produit (filtres Berkey) tout à fait conforme. Service client très réactif. Je conseille.