Eva Fountain - installation of the fountain

Before starting the installation of your EVA fountain, wash your hands carefully with soap or a hydroalcoholic solution so as not to alter the natural filters. Remove the protections from your EVA Fountain then rinse all the elements with clean water. Install the ECO - RESPONSIBLE ceramic (n°2) DO NOT HOLD IT BY THE DOME, BUT BY ITS BASE. If you rotate the ceramic on its base, you risk separating it and thus breaking the bottom of the ceramic OR damaging the seal. Place the ceramic in the tank with a central hole (n°4), the interior seal (n°3) of the ceramic must be positioned inside the tank (n°4). Screw the butterfly (n°5) of the ceramic, without forcing, finally rinse under clear tap water. Take the filter cartridge (n°7) and follow the instructions (page 19). Remove its packaging, then immerse it in a container filled with water to release air bubbles (2 to 3 minutes). During this operation, prepare the base (n°14) on which you will place the second tank (n°9) for receiving filtered water. Screw in the tap (n°12), insert it into the hole provided. There are 2 seals for sealing: 1 inner seal + 1 outer seal, position them correctly to obtain the desired seal. Take the nut (rounded side to screw against the joint), screw without forcing and above all without crushing the joints. Take the blue basket (n°10) filled with minerals and rinse it under tap water to eliminate excess mineral dust and place it in the center of the second bin (n°9). For BEP models, the white magnetic disk is already installed in the blue bin (n°10), you just need to add the green IRL piece (n°11) to the center of the bin lid. Place the large cup (n°8) on the second tray (n°9)

Place the cartridge (n°7) under tap water to finish purging it, black water may flow out due to the activated carbon, as soon as the water is clear your cartridge is ready for use. Screw the filter cartridge (n°7) onto the small cup (n°6) (fixing cup) and insert it into its location. Then place the tray with the ceramic (n°4+n°2+n°3+n°5) on the large dish (n°8) and place the lid (n°1) on top of the fountain. Your fountain is ready. Put water in the upper tank (n°4) and let it filter. After assembly, YOU MUST PERFORM 4 FILTRATION CYCLES before consuming the water: fill your upper tank for the first time, let the water flow into the lower tank and give the filtered water to your plants. Repeat this operation three times. EMPTY ALL OF THE WATER IN THE LOWER TRAY (tray where the tap is located) AT THE END OF EACH CYCLE After these filtrations, YOUR EVA FOUNTAIN IS READY... PLEASE NOTE: IF YOUR LOWER TRAY IS ALREADY FILLED WITH WATER, YOU MUST NOT ADD WATER TO THE UPPER TRAY OTHERWISE IT WILL OVERFLOW THE EVA FOUNTAIN does not have an anti-overflow system. For people suffering from kidney or urological problems, it is strongly recommended to inform their doctor about the use of the EVA Fontaine.